Trlon air conditioner manufacturers have silent cooling towers, closed cooling towers and cooling tower noise reduction, maintenance and transformation services.
National Service Hotline National Service Hotline:

4008-8383-95

Your current location:HOME > News > FAQ

FAQ

Closed cooling tower manufacturers tell you the advantages of cooling towers and solutions to common problems

Author:Trlon  Views:  Time:2020-12-21
Closed cooling tower manufacturers tell you the advantages of cooling towers and solutions to common problems

Tell everyone why the cooling tower catches fire?

   There are two reasons: one is that the wiring between the cooling tower motor and the distribution box is seriously aging, which leads to leakage and connection, etc.; the other is the improper operation of the workers during the maintenance of the cooling tower and the sparks generated during welding or cutting. Fire; this is the main and most direct cause of fire in the cooling tower.

How to deal with Legionella in cooling towers?

   1. Chlorine dioxide disinfection Add high-concentration chlorine dioxide disinfectant to the circulating cooling tower water, control the chlorine dioxide concentration to 30mg/l, and disinfect for 24-36 hours. 2. Photocatalytic water processor installed on the photocatalytic disinfection cooling tower: TiO2 foamed nickel metal mesh (20cm×20cm/piece, 20 pieces in total) and 4 30W ultraviolet lamps. When the disinfection starts, start the photocatalytic water treatment …ERUCooling tower noise reduction treatment manufacturer
  Are many water turbine cooling towers used?ERUCooling tower noise reduction treatment manufacturer
  As a new thing, especially in the era of "low carbon, energy saving and environmental protection", the utilization rate of water turbine cooling towers is still very low, and it is urgent to accelerate the promotion. Item 26 of the "National Key Energy-saving Technology Promotion Catalogue (Third Batch)" proposed by the National Development and Reform Commission 2010 No. 33, specifically planned to promote the technology of industrial cooling tower Francis turbine technology. It can be seen that the promotion of cooling tower turbine technology is important …ERUCooling tower noise reduction treatment manufacturer
  How to clean the cooling towerERUCooling tower noise reduction treatment manufacturer
   If the cooling tower is left outside for a long time, it will be exposed to sand and dirt, especially the fan part. Such operation for a long time will reduce the cooling tower's heat dissipation capacity. How to clean the cooling tower? 1. First, drain the water from the cooling tower's water tray, and start cleaning from the water distributor on the tower, so that the water distributor can supply water normally and evenly. (For example, use tools to unblock the water hole gambling game).
Cooling tower manufacturers

What is a blast cooling tower

  Cooling tower is a kind of thermal equipment that is widely used. Its function is to dissipate the heat of high-temperature cooling water into the atmosphere through heat and mass exchange, thereby reducing the temperature of the cooling water. Cooling towers can be divided into different types according to different classification methods. Among them, according to the ventilation method, there are natural ventilation cooling towers and mechanical ventilation cooling towers. Mechanical ventilation cooling...

What is the difference between evaporative condenser and closed cooling tower?

   1. Closed cooling towers take water, while evaporative condensers take other refrigerants. The fundamental difference is that the evaporative condenser has a phase change in the cooled medium, but closed cooling towers do not. The so-called condensation is to condense the temperature of the gaseous state into a liquid state. These are called evaporative coolers. 2. The evaporative condenser must be connected to a closed system, which basically has a certain pressure. seal…

How to solve the problem of water floating in the cooling tower?

The standard drift rate of the cooling tower is generally 2%-5% of the circulating water volume. When the cooling tower is running, you can see that the cooling tower sprays a lot of small water droplets, like white mist, indicating that the cooling tower has serious water drift . Analysis of the floating water of the cooling tower: 1. The fan rotates at a high speed, resulting in strong air suction, which draws a large amount of small water droplets out of the cooling tower from the air cylinder; 2. After the hot and humid air leaves the cooling tower,
Cooling tower packing

Cooling tower packing material distinction

  As the core of the sewage cooling tower, the filler accounts for 20%-30% of the total cost of the sewage cooling tower, but it shoulders 60%-80% of the cooling capacity. The excellent filler properties can greatly improve the cooling efficiency of the cooling tower and play the role of the filler, which is an important aspect of improving the performance of the cooling tower. Sewage cooling towers are mostly used in industrial industries, and they are in a very harsh sewage environment.
Closed cooling tower manufacturers

The working principle of closed cooling tower:

  1. The closed cooling tower is actually an evaporative cooling tower, a combination of a cooler and a wet cooling tower. It is a horizontal evaporative cooling tower. The process fluid flows inside the tube and the air flows outside the tube. Both Do not touch each other. The closed cooling tower is a modification and development of the traditional cooling tower. After the water in the reservoir at the bottom of the tower is pumped by the circulating pump, it is sent to the outside of the pipe and sprayed down evenly. It is not in contact with the process fluid hot water or refrigerant and the air outside the pipe, and becomes a closed cooling tower. The effect of heat and mass transfer is enhanced by spraying water.ERUCooling tower noise reduction treatment manufacturer
  2. The closed cooling tower is suitable for various cooling systems that require high circulating water quality. It has application prospects in electric power, chemical industry, steel, food and many industrial sectors. On the other hand, compared with air-cooled heat exchangers, evaporative cooling towers use the latent heat of evaporation of the water on the lower side of the tube to significantly enhance heat and mass transfer on the air side, which also has obvious advantages.ERUCooling tower noise reduction treatment manufacturer
   Closed stainless steel cooling tower, as a kind of cooling tower, adopts the method of placing the heat exchanger in the stainless steel cooling tower. Through the air circulating in the tower, the spray water and circulating heat are exchanged to ensure the cooling effect of the cooling tower. Because the equipment uses a closed internal circulation method, it can ensure that the quality of the water is not polluted by work, which not only protects the more efficient operation of the main equipment of the cooling tower, but also increases the service life of the cooling tower itself. Because the stainless steel cooling tower is equipped with an automatic temperature control device, when it senses that the outside temperature is low, it can automatically close the water spray system and stop running, which saves water use.ERUCooling tower noise reduction treatment manufacturer
  The price of closed stainless steel cooling tower is affected by the selection and material. Stainless steel cooling towers are made of aluminized zinc plate, FRP and stainless steel. The cooling coils are also divided into copper tubes, T2 copper tubes, stainless steel tubes and carbon steel tubes. The cooling water volume of the cooling tower ranges from 1T to several hundred tons. According to the market situation of cooling towers this year, the development of cooling towers is relatively stable. Therefore, the price of stainless steel cooling towers is mainly affected by raw materials, and the overall average price is stable.ERUCooling tower noise reduction treatment manufacturer
   The larger the design water volume of the closed stainless steel cooling tower, the more cooling coil water volume will be required. The raw materials used in the cooling coil are stainless steel pipes, copper pipes and carbon steel pipes. The price of carbon steel pipe is the lowest, and T2 copper is better. Therefore, the price of stainless steel cooling towers will vary greatly. The price of copper pipes of the same thickness can be twice as high as that of carbon steel pipes. The dense structure of the surface of the stainless steel tube can effectively reduce the formation of scale. The production cost control of closed stainless steel cooling towers can be divided into multiple grades in the production materials of the cooling towers.ERUCooling tower noise reduction treatment manufacturer
  When many companies buy stainless steel cooling towers, they will compare and compare multiple production plans. However, the price of stainless steel cooling towers that are almost the same sometimes varies a lot. To a certain extent, this will cause a certain cost increase due to the local raw materials and production labor. However, if the price difference of the stainless steel cooling tower is too great, then it is necessary to consider whether the production material of the enclosed cooling tower is a real material.ERUCooling tower noise reduction treatment manufacturer
   At the same time, this kind of stainless steel cooling tower can also save more manpower for the production company. It is like saying that anti-freezing work is required when the general cooling tower is not used, but the stainless steel cooling tower does not need to do this work. The reason is because the stainless steel cooling tower adopts a fully enclosed water circulation system, and the water surface has little contact with the air, and the heat preservation effect will be very good, so there is no need to do any antifreeze work. This will save the company more manpower.
Closed cooling tower manufacturers
Advantages of closed cooling tower products:ERUCooling tower noise reduction treatment manufacturer
  Improve production efficiency, soften water circulation, no scaling, no blockage, no loss;ERUCooling tower noise reduction treatment manufacturer
  Extend the life of the equipment, ensure the reliable and stable operation of the equipment, reduce failures, and prevent accidents;ERUCooling tower noise reduction treatment manufacturer
  Fully closed loop, no impurities enter, no medium evaporation, no pollution;ERUCooling tower noise reduction treatment manufacturer
  Improve the utilization factor of the plant, no need for a pool, reduce land occupation and save space;ERUCooling tower noise reduction treatment manufacturer
   Small footprint, convenient installation, movement and layout, compact structure;ERUCooling tower noise reduction treatment manufacturer
   Easy operation, stable operation, high degree of automation;ERUCooling tower noise reduction treatment manufacturer
   Save operating costs, multiple modes automatically switch, intelligent control;ERUCooling tower noise reduction treatment manufacturer
   has a wide range of uses, and can directly cool the medium that is non-corrosive to the heat exchanger; ☆ low operating cost throughout the life, high initial investment, low operating and maintenance costs;ERUCooling tower noise reduction treatment manufacturer
   The main raw materials and types of closed cooling towers:ERUCooling tower noise reduction treatment manufacturer
   1. For the motor, it is necessary to choose a completely enclosed product with a quality certificate to prevent circulating water from floating into the motor during the working process, causing the motor to burn.ERUCooling tower noise reduction treatment manufacturer
  2. The water collector, filler, the water collector, and the filler must be made of Formosa Plastic PVC material with heat insulation and antifreeze, so that the effect of the equipment will not be affected regardless of the hot summer or the severe cold winter.ERUCooling tower noise reduction treatment manufacturer
   3. Cooler. The cooler is the core part of the closed cooling tower. Generally, the wall thickness of φ22 copper tube is ≥0.6mm, because among the many metal elements, the corrosion resistance, heat transfer and cost performance of copper tube are all It is an ideal choiceERUCooling tower noise reduction treatment manufacturer
  4. Plate, cold zinc anti-corrosion plate of national standard, plate thickness ≥2mm. According to actual requirements, thicker or thicker galvanized panels can also be used, or stainless steel panels can be selected.ERUCooling tower noise reduction treatment manufacturer
   5. Circulating pump, the same principle as the motor selection, the circulating pump should also choose a fully enclosed water pump.ERUCooling tower noise reduction treatment manufacturer
   Both manpower and financial resources are what the company needs most. Therefore, stainless steel cooling towers can become the leader in the cooling tower industry in the market, opening up a broader market for the cooling tower industry. Guangdong trlon specializes in the production of cooling towers, open cooling towers, closed cooling towers and other process water cooling and gas condensation equipment. We have advanced production technology, strong technical force, excellent product quality, and perfect after-sales service. According to the different needs of customers, we can customize products that best meet customer requirements. Welcome to inquire!
 

Article Address:https://www.trlen.com/baike/277.html

News

Contact

Guangdong Trlon Energy-saving Air Conditioning Equipment Co., Ltd.

Contact:Mr. Wang

Free Hotline:4008-8383-95

Company Email:sales@trlon.com

Web Site:https://www.trlen.com/

Company Address: 1916A, Block A, David Donglong Business Building, Longhua, Longhua District, Shenzhen

Trlon WechatClose
alibaba